|
|
Home > Paints, Thinners, & Additives > Primers & Undercoats >
Interlux Epoxy Primekote
Epoxy Primekote
|
Interlux Epoxy Primekote is a multi-purpose two-part epoxy primer for use above the waterline.
|
Epoxy Primekote is a multi-purpose two-part epoxy primer that is the recommended primer for use with two-part finishes such as Perfection® Polyurethane and can also be overcoated with any Interlux topside paint. It is also used as part of a system to resurface cracked and crazed gelcoat prior to the application of topside paint and over clear epoxies to eliminate the effects of amine blush. It’s bright white color makes it ideal for priming bilge and locker areas.
- Suitable under all Interlux topside finishes
- Can be used to re-surface cracked and crazed gelcoat prior to the application of topside paint
- Can be used over clear epoxies as a sanding surfacer and to eliminate the effects of amine blush
- Application by spray or roller/ brush
Preparation
BARE FIBERGLASS: Degrease by wiping with a rag soaked in Fiberglass Solvent
Wash 202 or Fiberglass Surface Prep YMA601. Abrade with 120-220 grade (grit) paper. Remove sanding residue.
CLEAR EPOXY: Allow three to five days for clear epoxies to cure fully. Remove amine blush by using Fiberglass Surface Prep YMA601. Sanding does not remove contamination. Rinse with fresh water and allow to dry. Abrade with 80-120 grade (grit) paper. Remove sanding residue. Sand with 80 grade (grit) sandpaper and remove sanding residue with Brushing Reducer 2333N. Repair any defects with Interfill Epoxy Filler or Watertite, then sand with 120-220 grade (grit) paper and clean with Brushing
Reducer 2333N.
BARE METAL: Surface should be blasted to bright metal. If blasting is not possible, grind with 36 grade (grit) discs. Apply one very thin coat of Viny-Lux Primewash 353/354. Allow to dry for 1-24 hours. (but no more than 24 hours).
BARE WOOD: Sand surface with 80-120 grade (grit) paper, wipe clean.
|
|