Bilge Pumps

Bilge Pumps - Rule Pumps

Rule-Mate automated bilge pumps feature a pump and a non-contact, mercury free float switch in a single, compact housing. When the float rises, the pump begins to turn on. It will delay its activation for two seconds, thus eliminating any false starts. There is no on/off cycling and therefore no power use until the pump comes on. When the float drops and the pump senses no load against the impeller, the shut-off phase begins. At that point the pump will remain on for an additional 15 seconds allowing the pump to take the water level remaining from 3/4 in. to about 3/8 in., drastically minimizing odors and excess water. A great benefit to boaters everywhere!

Automatic Bilge Pumps

These feature computerized operation on the principle of impeller resistance. Float switches are not required. The pump will turn on every 2-1/2 minutes for about one second to sense for water. If water is present, the pump will sense resistance and continue to run until all water is removed. When the water's gone, it will resume checking for water every 2-1/2 minutes. Power use in the checking mode is minimal.

Also available are a number of Automatic, automated and manual bilge pumps, and bilge pump accessories, including float switches, panel switches, pump hoses and hose clips. Our pumps are made from such marine plumbing specialists as Rule, ITT Jabsco, Attwood, Johnson and Seachoice.