Surface Preparation: Best when used as a surfacer over other Awlgrip Primers. May be applied by brush or roller directly to properly prepared wood or fiberglass. Best results are obtained whem these surfaces are first sealed with 545 primer.
Mixing and Reduction - Spray: Mix by volume 1 part D8003 base with 1 part D9001 until a smooth homogenous mixture is obtained. Reduce as necessary up to 50% with spray reducer T0006.
Brush/Roll: reduce mixed D8003/D9001 as needed up to 50% with T0031.
Induction time after mixing is 15 minutes.
Pot life is 8 hrs at 77 F/50% relative humidity.
Application Instructions:
Spray - apply Awl-Quik sanding surfacer in smooth coats of 4 to 6 mils (100-150 microns) WFT yielding 2-3 mils (50 to 75 microns) DFT. Allow 4 hrs between coats at 77 F/50% RH.
Brush/Roller - Two coats will be required. Light sanding between coats will improve appearance. For large surfaces rolling, then tipping with a brush is preferred.
Do not apply to surfaces less than 3 C/5 F above the dew point, to surfaces warmer than 41 C/105 F, or when ambient temperature is outside the range of 13 C/55 F - 41 C/105 F.