|
|
Home > Paints, Thinners, & Additives > Primers & Undercoats >
AwlGrip High Build Epoxy Primer
High Build Epoxy Primer
AwlGrip High Build Epoxy Primer is a two component epoxy primer for use where high build and filling is required. Not to be used below the waterline.
Best when used as a surfacer over other AwlGrip Primers and Fairing Compounds. High Build primer may be applied directly to properly prepared wood or fiberglass; however, best results are obtained when these surfaces are first sealed with 545 Primer.
- Type: Epoxy Polyamide
- Packaging: Available in 1 gallon and 1 quart containers
- Theoretical Coverage: Sq. Feet/Gallon793 Sq. Feet at one mil dry 113-158 Sq. Feet at recommended dry film thickness. Calculated for mixed base and converter reduced 20%.
- Coverage calculations are based on theoretical transfer efficiency of 100%.
- Actual coverage rate obtained will vary according to equipment choice, application techniques, part size, and environment.
- Recommended Wet Film Thickness: 8-10 mils (200-250 microns)
- Recommended Dry Film Thickness: 5-7 mils (125-175 microns)
- Recoatability: With itself, 4 hours; with other products, 12-24 hours. Maximum without sanding: 24 Hours.
- Sanding before overcoating with other products is recommended.
- May be overcoated with 545 Epoxy Primer, ULTRA-BUILD, Sprayable Fairing Compound, AWL-FAIR L.W., and AWL-QUIK.
- VOC: White Base D8002 - 347 g/lt or 2.9 lbs/gal. Yellow Base D9002 - 338 g/lt or 2.8 lbs/gal
*** FOR PROFESSIONAL USE ONLY ***
|
|